bolt-on kaela poldid ?

[Death Super Mario]

Kitarri kael on 28.7" mõõtskaalale. Vaja leida sobivad poldid kinnituseks. Kerel on 3mm augud.
Kaela kinnitus plaat on eebenipuust 3mm aukudega 6mm paksusega. Poldi pea peab olema lapik.

3mm asemel ma paneks 4 või 5mm läbimõõduga poldid. 3mm paistab liiga nõrgaks jäävat.
3mm võin ka panna kui sobib.

kui ma liidan
Kaela paksus 20mm
kaelatasku paksus 22mm
kaela kinnitus plaat 6mm
saan 48mm paksuseks

Stewmac'is müüdava kaela kinnitus plaadi kruvide pikkus on 44.45mm
Kui liidan kaela kinnitus plaadi paksuse juurde saan 50mm.

[Death Super Mario]

Sain targemaks. Panen 45mm pikad poldid.

1. Verify the screws arent too long. if the screws get near the
fret board they will lift it up.
2. Drill piolet holes slightly smaller than the screws so you
dont crack the wood.
3. Hold the drill bit along side the neck and put some tape around
the bit where you want to stop for maximum depth.
4. Start the holes with the neck in place so the spacing is correct
finish it with the neck removed so you can use that tape as a
depth guage
5. Put some soap on the screws so they screw in smoothly